You have already subscribed to our newsletter.
You successfully unsubscribed from our newsletterContinue Shopping
TROUBLESHOOTING | Avoid micro foam in coatings
The challenge of micro foam
Foam is the result of air distribution in the coating. Here, gaseous bubbles emerge in the coating or on the coating‘s surface. If foam occurs in the coating container or coating pan, processing problems may be the consequence. This is followed by transfer disturbances or air inclusions in the dried coating layer.
The coated printed product looses gloss and/or scuff resistance. If foam appears in the chambered doctor blade or roller system, a (partial) drying of the coating is possible. Depending on the level of contamination, this may even lead to malfunctions of the printing press. The most usual reason for foaming is the fast pumping of the coating in the container (circulation of coating suction and return flow) and in the printing press.
Solving micro foam in coatings
Step by Step
1. Re-position coating suction and return flow
If coating suction and return flow are positioned incorrectly, air can be taken into the coating. Strong foaming is the result. Therefore, install coating suction and return flow deeply below the coating‘s surface on the wall of the container.
If foaming continues to increase, return flow should be positioned above the coating‘s surface on the wall of the container so that the surface of the returning coating is as large as possible. This supports faster foam degradation.
2. Reduce the speed of your coating pump
If your coating pump is running too fast, foam (mostly macro foam) may easily be formed. Choose the speed of your coating pump just as high as it is necessary for the coating unit to be filled and emptied properly.
New high-speed printing presses that mainly print large formats work often with a low volume chambered doctor blade system. In this case micro foam can be reduced by an increased pumping capacity and thus also and increased flow rate.
3. Apply defoamer
Defoamers eliminate and prevent foaming. If you add defoamer to your coating, pay attention to the correct dose. Otherwise it may come to an incompatibility between defoamer and coating. The consequence: altered coating characteristics and/or surface disturbances in the dried coating layer.
If you add defoamer to your coating, always ensure that the defoamer is thoroughly incorporated into the coating. If defoamer is added at the printing press, sufficient mechanical stirring is absolutely necessary so that the defoamer achieves its desired results.
4. Choose another coating
Many coatings contain raw materials with a foam-building structure. These raw materials determine the foaming behaviour of a coating. Often, they are necessary for the functionality of the coating. A replacement is hardly possible. Please contact your technical representative or use the contact form below.
5. Do you use the correct type of coating pump?
Fast running membrane or rotary pumps can positively influence the occurrence of foam. A peristaltic pump operates in a gentler way. However, increasing the flow rate to reduce micro foam is not possible when working with peristaltic pumps as they do not produce a sufficiently high flow rate.
YOUR SHORT CHECKLIST
Influence factor: Circulation
Measure: Flow line deep under the coating´s surface, return flow just above the same
Influence factor: Pump (1)
Measure: Reduce speed
Influence factor: Troubleshooting
Measure: Apply defoamer
Influence factor: Coating
Measure: Apply apprporiate coating alternative
Influence factor: Pump (2)
Measure: Peristaltic instead of membrane pump
Still have open questions? Contact us and we will support you with the application.CONTACT US
Discover the Troubleshooting Series
The Troubleshooting Series is your source of content with smart tips that helps you to make the most of all ACTEGA products in your processes. In addition to state-of-the-art chemical specialties for the packaging industries, we are your knowledge partner by offering you our technical expertise and useful information.
Discover all of our content