TERRAWET® Matt Coating G 9/123 soft-060
suitable for sealing against PET A/G, PVC and board
- 涂料
- 水基
Product Details
Markets
- 纸质包装
Application method recommendation
- Wet-in-wet
- Coating unit
- Wet-on-dry
- Sheet-fed offset, coating unit (chambered doctor blade or roller system)
- Sheet-fed offset, coating unit
- Please use printing inks/foil inks suitable for coating.
- In order to guarantee a fast and complete drying, we recommend a sufficient airing of the sheets.
- Recommended coating application: 5 - 10 g/m²/wet Recommendation: double coating
- There must be a suitability for water-based coating if anti-set-off powder is used (do not use mineral powder).
- Using non-absorbent substrates and / or slowly absorbent printing inks, we recommend to plan for the corresponding drying times.
- Stir well before use! Mechanical stirring is recommended.
- Before processing, please check the blister ability.
- The full profile of characteristics of the coating film is available after complete drying.
- There must be a sufficient hardening of the overall system substrate-printing ink-coating before further processing which shoud be checked in the process.
- Resistance against alkali, alcohol and solvents should be given according to DIN ISO 2836, formerly DIN 16524, in order to exclude a change of colour.
- Standard sealing conditions: - Temperature: 180°C - 230°C, depending on used material - Time: 2 - 4 sec., depending on used material - Pressure: 5 bar - In case of suitable board and foil qualities seali
- Recommended temperature: 18°C - 25°C. - Relative humidity: 50 % - 55 %
- For the further processing of the sheets under mechanical load and/or the influence of humidity, a sufficient high basic consistency of the substrate is required.
- Recommended pile temperature: not › 30°C
- Blister cards should be stored cool and on edge.
Product end use
- 玩具
- 吸塑
Substrate recommendation
- 涂层板
- 涂布纸