TERRAWET® Playing Card Coating G 9/920 ToySafe-040
very good playability, very high scuff resistance, ToySafe® certified
- Coatings
- Water based
Product Details
Markets
- Publication & Commercial
Application method recommendation
- Sheet-fed offset, coating unit (chambered doctor blade or roller system)
- Wet-in-wet
- Stir well before use! Mechanical stirring is recommended.
- Recommended coating application: 3,5 - 5 g/m²/wet
- The full profile of characteristics of the coating film is available after complete drying.
- Please use printing inks/foil inks suitable for coating.
- Recommended pile temperature: not › 35°C
- A low odour (GA) version is available.
- The coating is principally glueable (please test).
- We recommend to omit adhesive straps.
- In order to guarantee a fast and complete drying, we recommend a sufficient airing of the sheets.
- For the further processing of the sheets under mechanical load and/or the influence of humidity, a sufficient high basic consistency of the substrate is required.
- There must be a suitability for water-based coating if anti-set-off powder is used (do not use mineral powder).
- Resistance against alkali, alcohol and solvents should be given according to DIN ISO 2836, formerly DIN 16524, in order to exclude a change of colour.
- The coating is suitable for wrapping in foils XS and MS (no acrylic coated foil).
- Using non-absorbent substrates and / or slowly absorbent printing inks, we recommend to plan for the corresponding drying times.
Product end use
- Playing Cards
Substrate recommendation
- Coated Board
- Playing card board
- Coated Paper
Disclaimer
Product specifications are contained in the technical data sheet. Depending on the product, you can download this from the ACTEGA website or request it using the contact form. For more details, please refer to our product disclaimer here .